Lubrication’s study about bearings and development of a tribometer reichert method

Authors

  • Alan Mendes de Souza
  • Fabrício Ap. Ferraz da Silva
  • Felipe Amade de Souza
  • Carlos Humberto Sartori
  • Carlos Alberto de Freitas
  • Antonio Carlos Arruda

DOI:

https://doi.org/10.22567/rep.v7i1.498

Keywords:

lubrication, wear, friction, bearing, energy

Abstract

The study is intended to approach the possible failures in machine elements (bearings) manufactured  in  AISI  52100  and  its  main  wear  mechanisms, adhesion,  abrasion,  corrosion  and fatigue. the main types of lubricants will be presented, with an emphasis on oil and grease characteristics, physico-chemical and its major additives. The study was carried out a device that performed tests in the same 15W-50 viscosity lubricant at different periods of utilization 1000, 2000 and 3000 kilometers.Iit was possible to measure the breakage of the lubricating film due to the pressure exerted by the device and thus effectively exemplify the adverse effects on machine elements due to the poor management of lubrication.

Downloads

Published

2018-01-28

How to Cite

Mendes de Souza, A., Ap. Ferraz da Silva, F., Amade de Souza, F., Humberto Sartori, C., Alberto de Freitas, C., & Carlos Arruda, A. (2018). Lubrication’s study about bearings and development of a tribometer reichert method. Revista Eniac Pesquisa, 7(1), 82–96. https://doi.org/10.22567/rep.v7i1.498

Issue

Vol. 7 No. 1 (2018)

Section

Artigos

License

Copyright (c) 2018 Revista Eniac Pesquisa

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.